Come on with the terrible spools already

I have had no less than 8 rolls of filament that were no good right out of the box in the last two months. 1 was brittle and snapped with every turn and the other 7 almost seem like they are either very badly wound up on the roll that they get trapped and break in the AMS. When checking those I sometimes have to remove maybe an eighth of the roll to get past where it is trapped on the side. Several have almost appeared like they were melted or fused at spots (no I did not dry them first). I haven't even bothered contacting support because I see the run around that Bambu has given others with bad spools and honestly it just isn't worth my time to go back and forth in emails for a few lousy spools. Just wondering if others have experienced the same and what other brands that are more consistent in quality than Bambu since I'm thinking I'm going to dump Bambu as a filament supplier.