Issue on first large print on new A1mini

I just got an A1 mini and set it up last night. Made a benchy (printed very well in my newbie eyes) and a couple other small things that were all perfect.

I tried to leave this poop catcher/bin print overnight and was going smoothly when I last saw it but woke up to these stringy ends on one side. I watched it print for a minute before stopping it early, it would start the layer on the good side and then not quite reach the other side fully (I think) and then pause at the poop cleaner for a couple seconds before the next layer. Is that normal? Or possibly part of the issue?

Filament was brand new pla basic

What could be the issue?

On a side note my AMS lite arrived broken :( need to talk to support

Thanks for any help, new and trying to learn