3D print doubled in size
I printed my first Settlers of catan board game pieces They were supposed to come out Roughly a half inch tall But are a full inch.
Everything on the slicer as far as I know says this should not have happened and I'm not sure how it has Things I'm confused on 1. It continued the stairs in a diagonal fashion as if they were meant to be there 2. The top section all looks correct but the bottom half including the holes where the magnets are supposed to go are extremely long when it's supposed to be just a little divot 3. The stack of bricks on top are leaning two different directions when it's supposed to be perfectly Square 3. It happened to not just one but both models printed at the same time. Slicer shows it should be close to 14 mm tall so roughly around half inch but this is twice that