Sagittarius 8-bay build

Been looking for a smaller MATX build with hot swap. Current NAS was in a Fractal R6. Decided to order a Sagittarius 8 bay from Aliexpress on December 11 and it arrived today and I swapped my build into it. Could not find much information so figured I would post some and photos.

Everything went great but it is a tight build. If using a full size ATX psu you will need a low profile cpu cooler, think 53mm or lower. Shorter cables would be nice but these worked fine, I ran the 8 pin cpu connector through the drive cage area and out the hole in the top.

Currently im running a a thermalright low profile cooler without the fan, cause it was too large with the fan. Its actually running very well in unraid. Temps spike at 70 and hover around 45-50c. Ive ordered a lower profile cooler with a fan. The 53mm thermalright. This is using a 13600k cpu. This case supports 4 120mm fans. 2 pulling air over the drives and 2 pushing air over the motherboard.

All my drives detected immediately and you do not have to worry about 3.3v and shucked drives.

Aliexpress search link (i just found the cheapest cost + shipping who had good reviews)

https://www.aliexpress.us/w/wholesale-sagittarius-8-bay.html?spm=a2g0o.productlist.auto_suggest.1.502c29d5WQK7Wb

On to the photos

Fresh out of the box, the panel covering the drives is magnetic.

https://i.imgur.com/SwtwkDx.jpeg

Rear

https://i.imgur.com/HX0JmP6.jpeg

Backplane rear

https://i.imgur.com/3b9L4V0.jpeg

Closer backplane rear image

https://i.imgur.com/ukux5jm.jpeg